GLUE - ADHESIVES

Jinqiang JQ-2118 Adhesive Glue is a low cost solution and alternative to some of the higher priced EPP adhesive glue offerings   In our testing it works very similar to Welders & Beacon Adhesive glues.  Like all adhesive...

Expect the freshest Beacon Foam Tac glue(s) from Twisted Hobbys due to high turn over.  New redesigned tube and cap!  Great alternative to Welder Adhesive glue and CA glues when building your EPP models.  FOAM-TAC’S improved...

CEC-CORP C-Bond Thin is a low viscosity general purpose instant/cyanoacrylate glue. This glue comes with an anti-clog cap and has a 5-10 second cure time. C-BOND Thin has good penetration for fitting smooth surfaces. It can bond rubber, plastics,...

CEC-CORP C-BOND Thick is a high viscosity general purpose instant/cyanoacrylate glue. This glue comes with and anti-clog cap and has a 15-30 second cure time. Provides outstanding adhesion for porous surfaces and large gaps and could be used with a...

C-Set is a Super Glue Accelerator, also known as a glue “activator”. It is used to speed up the drying time of cyanoacrylate super glues. The accelerator is a solvent-based product that can be applied before and/or after the glue application...

CEC-CORP Instant Glue Plastic has low Viscosity and fast cure time even under low humidity conditions. It is designed for bonding Hard/Soft Plastics and Rubber, metal, ceramic and glass.  Cyanoacrylate glue is the industrial name for what...

C-POXY 30 4.25oz kit, is a general purpose fast setting epoxy adhesive. Recommended for bonding metal, ceramics, stone, glass, concrete, wood, fiberglass and many plastics such as polyester, ABS and rigid PVC (not suitable for PTFE-PP-PE and rubbers)...

Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the...

INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET™ in a spray bottle is normally used to cure the CA that flows from...

Blenderm tape is one of the best know tapes used for hinging and repairing your Depron or Epp models. Each 3M Blenderm key features are its high strength adhesive, extremely flexible and long lasting.   Each roll consists of 1" wide...

CEC-CORP Tips contains 5 nozzles. C-TIP is used for applying low viscosity Cyanoacrylate or instant glues to the finest cracks and gaps. The small nozzle can increase accuracy and provide more control in glue application.   Contains 5 nozzles...

Used for holding batteries, receivers, esc's or other components down.  Great addition for modeling. Includes: 2 pc (Male & Female) : Black 1" x 4" Velcro Hook & Loop sticky back  

Used for holding batteries or other components down.  Great addition tool for modeling. Includes: 1 pc : Blue 1/2 x 5 1/2 Velcro Strap

20 pc's plastic wire staples, great product for holding down wires for electronics, also used for LED kits.