GLUE & ADHESIVES

Blenderm tape is one of the best know tapes used for hinging and repairing your Depron or Epp models. Each 3M Blenderm key features are its high strength adhesive, extremely flexible and long lasting.   Each roll consists of 1/2" wide x 4m in...

Perfect choice for building and repairing your Twisted Hobbys EPP planes! This is the only adhesive you will ever need. Welder virtually bonds anything to anything! Clear, heavy-duty, flexible and water-proof when dry. Use indoors or out. (2) 1 oz tube...

Great alteritive to Welder Adhesive for sure on EPP Foam.  FOAM-TAC’S improved formula now contains UV blockers so that it can be used in the field in direct sunlight without any yellowing or degrading. We’ve also added a special...

Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the...

INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas,...

MAXI-CURE extra thick CA is the best CA for most plastics, including GE’s Lexan MAXI-CURE is the best choice for plastic model assembly. When used with INSTA-SET, it works better than any putty for modifying or filling voids. It can be carved...

One of the best EPP CA Foam glues unlike any other CA glues we have come across. SUPER-GOLD+™ are our odorless INSTA-CURE CAs They are non-frosting and take only 2 or 3 seconds longer to bond. There are no fumes that irritate the nose and eyes...

INSTA-SET is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization.  INSTA-SET in a spray bottle is normally used to cure the CA that flows from joints...

Maxi-Cure™ extra thick CA is the best CA for most plastics, including GE’s Lexan MAXI-CURE™ is the best choice for plastic model assembly. When used with INSTA-SET™, it works better than any putty for modifying or filling voids...

Pocket CA Extender Tip -  For use with BSI's Pocket CAs. It slips over the tip of the Pocket CA top to allow for finer application of the CA. With the tip, the CA can be applied to confined areas.

Used for holding batteries, receivers, esc's or other components down.  Great addition for modeling. Includes: 2 pc : Black 3/4" x 6" Velcro Hook & Loop sticky back

Used for holding batteries or other components down.  Great addition tool for modeling. Includes: 1 pc : Blue 1/2 x 5 1/2 Velcro Strap