Hacker Model Grimmershörn Ship Model
- SKU:
- Grimmershörn HC2500
Description
Hacker Model Grimmershörn boat kit. This is a hobby grade model, high attention to detail building required.
The Grimmershörn was built in 1956 - 1957 and served as a buoy-layer and pilot transfer boat. The 1:25 scale kit includes precisely laser-cut wooden parts for the hull, deck and superstructure. Also included are many plastic fittings, a drive shaft with stern tube, propeller and rudder set.
Drive, RC equipment, paints and adhesives are NOT included.
Hacker Models Power system: Link
Technical data:
Properties Grimmershörn
Scale: 1:25
Length: 830 mm
Width: 216 mm
Height: 475 mm
Properties Grimmershörn
Scale: 1:25
Length: 830 mm
Width: 216 mm
Height: 475 mm
Required materials (not included):
CA Glue & Activator Spray
UHU Allplast
Wood
Glue Glass Fabric and Resin
Spray Paint & Coating Paints
UHU Allplast
Wood
Glue Glass Fabric and Resin
Spray Paint & Coating Paints
Required accessories for driving (not included):
Drive set sprint boat 400 (motor/revesible esc/servo)
Remote control with at least 2 channels
Battery LiPo 7.4V with at least 2200mah
charger
Remote control with at least 2 channels
Battery LiPo 7.4V with at least 2200mah
charger
Related Products
Related Products
BEACON FOAM TAC - 1 oz. TUBE - EPP Models
$11.99
Expect the freshest Beacon Foam Tac glue(s) from Twisted Hobbys due to high turn over. New redesigned tube and cap! Great alternative to Welder Adhesive glue and CA glues when building...
Insta-Cure+ Super CA glue 3/4 oz
$6.99
Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together...
CEC CORP - Instant Plastic CA Glue 1 oz
$10.99
CEC-CORP Instant Glue Plastic has low Viscosity and fast cure time even under low humidity conditions. It is designed for bonding Hard/Soft Plastics and Rubber, metal, ceramic and glass...
CEC CORP - 30 Minute Epoxy 4.25oz
$19.99
C-POXY 30 4.25oz kit, is a general purpose fast setting epoxy adhesive. Recommended for bonding metal, ceramics, stone, glass, concrete, wood, fiberglass and many plastics such as polyester, ABS and...
Power Combo - Sprint Boat 400 Power Set HC3181
$129.99
BUNDLE AND SAVE! Motor 400/7,2V, with gear 1/3,5 and soldered bidirectional HACKER MDE18A controller, 1x servo 9g.
Used for the following Hacker Model boats: