Outrunner 2212 1000KV 55g "Crack Series Pro" Motor
- 55g 2212-1000KV CSP
- CSP 55g 2212-1000KV
- Bulk Pricing:
- Buy in bulk and save
While Twisted Hobbys has already been known for designing airplanes, we also create some of the most powerful small motors available and our Crack Series Pro series are the perfect example!
Our goal was to create the most powerful, better balanced, higher accelerating motor along with the highest quality components manufactured to Twisted Hobbys spec's. Quality without compromise! There is no mistaking the quality, reliability and overall performance of our Crack Series out runner motors. Tested, proven to outlast and provide you with endless flights!
Twisted Hobbys "Crack Series Pro" 2212-1000KV 55g Brush-less motor can used for any 13-16z foamie model. There is no mistaking the overall performance of the new Crack Series Pro 2212 1000kv motors. The 2212 is capable of 180/220 watts of power on 3s 650mah-1250mah lipo depending on setup, please see prop size for which lipo voltage.
Updated front 4 bolt prop hub. Designed for 38-39" TH/RCF EPP Models. Works directly with any of our 20A ESC to match the 2mm bullet connectors for a plug and play setup.
- 3s 450-850+mah w/ 10x3.8 or 10x4.7 Prop
- Stator Diameter: 22.0 mm (0.866 in)
- Stator Thickness: 13 mm (0.512 in)
- Number of Stator Slots: 12
- Number of Magnet Poles: 14
- Motor Wind: 26 Turn Delta
- Motor Kv Value: 970 RPM per Volt
- No Load Current (Io:) 0.45 Amps @ 8 Volts
- Motor Resistance (Rm) per Phase: 0.201 Ohms
- Motor Resistance (Rm) Phase to Phase: 0.134 Ohms
- Maximum Continuous Current: 14 Amps
- Max Continuous Power (3-cell Li-Po): 150 Watts
- Motor Weight: 55 grams (2.15 oz.) (including hardware
- Outside Diameter: 27.7 mm (1.091 in.)
- Shaft Diameter: 3.17 mm (0.125 in.)
- Motor Body Length: 28.0 mm (1.102 in.)
- Overall Shaft Length : 42.0 mm (1.654 in.)
- Motor Timing: 5-10 degrees
- PWM Frequency: 8kHz
- Heavy Duty 3mm Thick Cross Style Motor Mount
- Four M3x6mm Motor Mount Screws
- Bolt-On style threaded prop adapter with 4 screws (new upgrade)
- Retaining Collar with Set Screw
- Three female 3.5mm bullet connectors
- Three pieces of heat-shrink tubing
- Pre-Soldered 2mm Bullet Connectors (works directly with our 20A ESC)
Was hoping for more punch out of hover
Great power and very light. Great for 14 to 16 oz. 3D foamies.