TH 42" EPP Veloxity Green

21 reviews Write a Review
TH 42 Veloxity Green


From the Twisted mind of Cody Wojcik comes the Veloxity!  Loosely based on the full-scale Velox Revolution 1, the Veloxity delivers an experience never before available in a foam plane.  As one of the stiffest foam air-frames around, precision tracking, a fast roll rate, wild tumbles, knife edge spins, and other maneuvers normally reserved for wood airplanes are all within the Veloxity's repertoire.  With its consistent roll rate and arrow-straight tracking, the Veloxity may be the best rifle roll trainer out there!  Of course, pull back on the throttle and the Veloxity will 3D with the best of them.  A custom airfoil and carefully chosen moments means that smooth harriers upright, inverted, and rolling are stable and predictable, but not sloppy or imprecise...the Veloxity maintains precision through its whole flight envelope.

Backing up the Veloxity's aerodynamic and structural design is a proven power combo.  Armed to the teeth with the 100 gram Twisted Metal Works "Big Bell" motor, 12x6 prop, and 45 amp ESC, the Veloxity has a power level bordering on irresponsible.  The all new CSP D18M servos now offer great speed and centering with unstoppable torque.  The Veloxity is happy flying on 3S batteries as small as 1300, or as large as 2200 for six solid minutes of high energy insanity.

Building the Veloxity is a snap.  RCFactory's precision foam machining and laser cut wood, carbon, and fiberglass parts bond in quickly and easily into pre-cut slots and grooves.  In many ways the Veloxity builds as easily as a 32" flat plane, and a couple of easy sessions is all you'll need to get it together and ready to rip.  Controls are actuated with precision ball links that go together easily and pop off in a hard crash, saving servos.

Aspiring pilots need not fear the Veloxity!  With reduced throws and the throttle pulled back a bit, it's an easy airplane to fly and is extremely predictable.  It's a perfect step between 32" flat foamies and your first balsa bird.  The super strong airframe means that less than perfect landings and the occasional dirt nap will not keep you grounded!  Fly Rc Review
Model Spec's:
  •   Wingspan/Length = 42" (1060mm) / 43" (1120mm)
  •   AUW = 27-30oz. 
Required Power System Link:
Power System Components:
Other Requirements:
  •   Receiver/Radio  4 - 6 ch: Link  
  •   3s 1800/2200mah Lipo: Link
  •   Adhesive Glue :   Link
Build Resources & Replacement Parts Links

Extra Information


21 Reviews

  • Posted by Seth on Jan 15th 2020


    thickest EPP

    If you are looking at the this page and debating , stop it and click Add to cart. You will not regret it.
    I haven't measured it but I think EPP thickness is over an inch, I haven't seen an EPP foam this thick anywhere. Especially in a foamy. Quality is next to none. Im putting it together slowly to make sure it comes out as straight as possible. Thickness of EPP kind of makes it pretty straight too, there really isnt too much room for error. I will be using it with a HV setup to get the fastest servo throws possible .
    Can't wait to test this thing out.

  • Posted by Ike on Dec 3rd 2019


    Great flyer

    Great flyer but the landing gear and wheel assembly needs design revision hence my 4 star evaluation. Also precuts for aileron should be carried over from design like the crack yak