TH 39" EPP FLASH - Rain

4 reviews Write a Review
TH 39 FLASH - Rain


The Flash is an improvement of the original 3D trainer that used to be produced under the same name. Although the main parameters remained the same, the model was totally re-engineered for easier and straightforward build.  The model, which was originally designed as all-around 3D trainer capable of anything you might ask from it, was re-introduced after concentrated demand from our customers. You will appreciate the forgiving characteristics and smooth, linear response of this model - it will make your learning new 3D maneuvers a breeze.

Those that are familiar with the previous 39” models will appreciate the new hardware and construction methods with adjustable push rod assemblies EPP bracing techniques for easy assembly. While creating a new ground up air-frame the duel aileron servos were re-located to create a plush/clean look. The over all flight envelope has increased greatly giving a sense of unreal control authority and increased roll rate was also achieved with the addition of outer counter balance tabs. This model was designed for the pilot wanting to learn the “next step” and also those who choose a balsa 3d model alternative. * Spinner sold separately *

  Wing Span = 39"
  AUV: 375-390g (depending on components used)
  Full EPP construction
  Carbon Fiber landing gear
  Extra-large control surfaces
  Incredible control authority
  Smooth pattern performance
  Ideal 3D trainer
  EPP Durability.
Recommended Required Components:
  45-60g 1000kv brush-less motor
  20-30A ESC
  Micro Receiver
  (4) 10-16g Servo’s
  10x3.8/10x4.7 Slow Fly Prop
  3s 600-1200mah Lipo   

Extra Information


4 Reviews

  • Posted by Roy Rauch on May 23rd 2019


    Fun foamy!!!

    Finaly had a chance to build thiis foamy since its been on my self since February.
    Build went pretty good, about 5 1/2 hour just using the pdf file but I've have built a few of these foamys this way. Dont just use the measurement givin in the picture to assemble your pushrods. Use it as a reference and dry fit your pushrods before gluing.
    Everything went together pretty good!
    Balanced it, cut my hole for the battery and put her in the air. Very little trim was needed and flies very well and very stable and fun!!!
    I do recommend the Flash as a first 3D plane or and added for foamy to your hangar !!!

  • Posted by Cory on Oct 27th 2018


    Great plane in the 39'' size

    Just putting mine together and I know it will fly good.