cCopter 450mm Tri-Copter White

Twisted Hobbys' 450mm cCopter... a complete Tri-Copter kit for the multirotor enthusiast designed for ease of build and assembly.  High attention to detail has gone into designing this craft with its unique snap together features and limited number of parts for assembly.

As a sport flier, the cCopter is completely capable of cutting up the air at the local flying site, high speed passes, flips, rolls and any other maneuvers you might dream up. Potential payloads could include GoPro and Key Chain Style Cameras or even FPV gear and it’s associated components.
 
The design of the cCopter is such that the rear boom also doubles as a spine that runs the length of the airframe. The rear boom/spine and the front booms are all tied together with  plastic Upper and Lower Deck plates. The design intent of this construction method is to provide a durable inner structure and an easy to replace and inexpensive outer airframe. The front feet and tail box, could literary be replaced at the field with a couple simple tools and a few minutes time. Another design consideration was the general shape, something that would be easy to gage orientation from while flying. No need for colored booms or lights to tell which way is forward on this airframe.

Each kit comes with all parts ready to assembly with very little work or tools required.  Aluminum booms are all pre drilled and tapped also all plastics and hardware are included. Please note this is for an airframe only, all electrical components are purchased separately.

Specs and recommended components required:

• 450mm Airframe Size / AUW 22-24oz (depending on componets and battery weight)
• 3s 1600-2200mah
• 6ch Micro Receiver
• Flight Control Board
• (3) 40-60g 900-1200kv outrunners
• (3) 18A-30A ESC's
• 11-18g MG Tail Servo

Pdf Manual

Multirotor Magazine Review!

Rcgroups Build Thread