TH 33" EPP Synergy SUPER-LITE

TH 33" EPP Synergy Super Lite

Designed by RC Factory team pilot Jan Votava, the Synergy combines his F3A precision-flying experience with the lightweight performance required for indoor aerobatics and F3P competition.

Its narrow wing, large canalizers, and lightweight construction provide a smooth, predictable, and linear response. The Synergy can fly slowly and calmly for pilots entering indoor flying while retaining the precision required for advanced rolls, flips, and competition maneuvers.

Features and Specifications

• Designer: Jan Votava
• Wingspan: 835 mm / 32.9 inches
• Length: 945 mm / 37.2 inches
• Estimated Flying Weight: Approximately 115 to 145 g / 4.1 to 5.1 oz, depending on equipment
• Construction: Lightweight printed EPP with carbon-fiber reinforcement
• Wing Design: Narrow wing with reduced tip area and enlarged canalizers
• Flight Characteristics: Slow, stable flight with predictable and linear control response
• Recommended Battery: 2S 360 to 450 mAh LiPo
• Flight Style: Indoor precision, pattern aerobatics, freestyle, and F3P competition
• Flying Environment: Indoor facilities or calm outdoor conditions
• Pilot Level: Beginner to Advanced

Required to Complete

This is an airframe kit requiring assembly. The power system, radio equipment, battery, charger, and adhesives are sold separately. No printed manual is included; a downloadable PDF manual is available under Build Resources below.

Matched Power-System Components

• CSP 2203 1800KV brushless motor
• BOLT 16A brushless ESC
• One CSP-D10M and two CSP-D6M servos, or three CSP-D6M servos
• GWS 8 x 4.3 slow-fly propeller

The Synergy is designed around a lightweight conventional power system. High-output reversible 4D systems are not recommended because their added weight and rapid thrust changes are not well suited to the aircraft’s slow-flying design.

Additional Required Items

• Compatible 4 to 6-channel transmitter and lightweight receiver
• 2S 360 to 450 mAh LiPo battery
• LiPo-compatible balance charger
• Foam-Tac, thin CA, and medium CA adhesive

Build Resources and Compatible Parts

• Download the Synergy PDF Build Manual
• Shop Compatible 32 to 34-Inch Replacement Parts

We recommend Foam-Tac for the main EPP assembly and thin or medium CA where specified for carbon-fiber reinforcement and hardware connections.