Electronics & Power Systems

Wait!!! Don't remove your servo if you have control surface flutter which is very common on most all 3D aircraft's.  Once p

Used as another option to hold adjustable end-links to control horns instead of the tiny black factory ring-clips.  They are an easy on/off rear type of connection to the adjustable end-links.  *...

JST 4" Male to Female Connection Cable used for extension battery or esc battery connections. 

JST 6" Male to Female Connection Cable used for extension battery or esc battery connections.  Can be used for the Raptor battery locations.

JST Parallel Connection Cable used for connecting two esc's and two motors with one battery source.  Used on Puddle Star model.

JST-XH to JST LED Power Distribution Lead.  Great way to connected multiple LED's to a 3s lipo balance plug/port. We recommend checking +/- polarity when plugging in. - Used for large LED kit. ...

Males side of JST connector, can be used for lipo batterys connectors 

Used for esc to battery connection

  Features:  

Dean Style Plug Connector Male and Female *low-resistance *This design elimina

XT30 2mm Connectors: 1 pc: Male 1 pc: Female  

Made from high-temp Nylon and gold plated spring connectors, both included in the injection mold at the time when forming the connector. The XT60 ensures a solid high-amp connection, perfect for...

XT60 Female Connector

XT60 Male Connector

 

Set of EC3 connectors including one Device Connector and one Battery Connector for matching up batteries to speed controls, charger leads, power meters or other similar applications.

Diameter: 2mm male to 3.5mm female adaters (3 pc's).  Perfect for when you want to use different motor or esc without the soldering.

Diameter: 2mm Includes:: -3 Male connector -3 Felmale connector

21" 3 wire 2mm bullet female and male extension lead wires.  Great for motor setups that are long distances from ESC.   Used for: <

Diameter: 3.5mm  Includes: -3 Male connector -3 Felmale connector

Includes:1 x 19cm (7.5") JR Servos Extension High quality JR standard servos extension lead:

Includes:14cm (5 1/2) JR Servos Extension (with locker) High quality JR standard servos extension lead:

Includes:1 x 30cm (12") JR Servos Extension High quality JR standard servos extension lead:

Includes:1 x 9cm (3.5") JR Servos Extension High quality JR standard servos extension lead:

MG25 Flight controller for Multi rotors Support AV241,QAV250, 450, 460, and etc quad rotors, Support Autolevel mode, and Manual mode 102501 MG25 Flight Controller for Quad rotors. MG25 flight...

1. Features: NX3evo provides four different levels of flight modes: 1, Beginner 2, Practice 3, Advanced 4, Expert. Four wing types: Single (Dual ailerons)/Delta wing/V-tail. Separate gain adjustment...

Power Combo with Pylon for the RookieAdd a lightweight electric motor to your Rookie and enjoy nearly unlimited flig

BUNDLE AND SAVE! Motor 400/7,2V, with gear 1/3,5 and soldered bidirectional HACKER MDE18A controller, 1x servo 9g. Used for the following Hacker Model boats:

BUNDLE AND SAVE! HC3185 (2x DC motor SPRINT 600/12V BOAT, 1x DC motor SPRINT 400/7.2V, 2x regulator 56A, 1x regulator 16A, gearbox 1/3.5), two standard servos cat. no. HC4348

Electronic timer for Control Line models from Rc Factory  Electronic timer for controlling an AC controller  Easily adjustable fl

Looking to lower voltage with a 3-9s lipo, this is the solution.  Very simple setup to reduce voltage and plug directly into your receiver directly.

Replacement Servo hardware bags for CSP-D6M servos 

Replacement Servo hardware bags for CSP-D10M servos 

Replacement Servo hardware bags for CSP-D14M servos 

Replacement Servo hardware bags for CSP-D18M servos 

Need to see where your racing!  These are perfect for FPV race courses, includes 24 pc's of white arrow made from corrugated plastic.

The new transparent iron-on film with enhanced adhesion, which can be applied directly to EPP, is now available. It tolerates a wide range of temperatures on a typical modeling iron, but we advise...

The new transparent iron-on film with enhanced adhesion, which can be applied directly to EPP, is now available. It tolerates a wide range of temperatures on a typical modeling iron, but we advise...